The top of the electric jack is made of high-strength nylon 66 material, and in real life, the replacement of the car tires has always been a headache for the driver, especially on the wild side of the road, in the hot summer, cold winter and drizzle Of the weather conditions, with hand-cranked (mechanical) jack to replace the tires is very time-consuming, laborious, individual gentleman, ladies have no strength to the car to the top, every time tired of sweating, and whole body mud The Tough anti-skid, effectively prevent the paint with the car surface. Package Included 1 x Electric jack 1 x Electric wrench 1 x Manual remote control 1 x Remote control 1 x Battery power cable 2 x Double-headed sleeve (17-19 21-23) 3 x Spare fuse 1 x Hand crank 1 x Crowbar 1 x Cigarette lighter power cable 1 x pair of gloves. Load bearing: Bear 5 Ton.
Maximum carrying value: 5 Ton. Power: 12V DC Top material: high strength nylon 66 Features Overload protection: When the load exceeds the rated load automatically stop working, protect the product from damage and operator safety.
Instructions for use 1, electric charge use: the car parked on the level of the road, the engine flameout, and do not forget to tighten the hand brake. Put the electric jack placed in the tires near the body under the steel beam, and the top of the electric jack on the bottom of the car under the support point, so that the electric jack can be safe and effective lifting. (3) Connect the electric jack to the 12V power supply in two ways: use cigarette lighter connection: one end of the cigarette lighter plug into the cigarette lighter socket, the other end of the 5.5mm plug into the electric jack on the 5.5mm plug seat.
(Note: cigarette lighter fuse rated current shall not be less than 10A) Use the vehicle battery to connect directly: Insert one end of the cigarette lighter plug into the cigarette lighter socket at one end of the battery clamp, and hold the red clip on the other end of the battery clip and hold the battery "+" (positive) Battery "-" (negative) connected, and then plug the other end of the cigarette lighter plug 5.5mm plug into the electric jack on the 5.5mm plug seat. Use the operation: to determine the first few steps to do a good job, you can start the lifting operation. Hold the remote control and press the button on the remote control as needed. Means rising, means descent, means stop.In the process of jacking up, should carefully observe the jacking dynamic, to ensure that the electric jack is not tilted until the wheel and the ground away from the 20mm, the wheels can be free to stop when lifting, replace the tires. 2, the use of electric wrench: When the replacement wheel leaves the ground, connect the electric wrench to the power supply (insert the 5.5mm power plug on the electric wrench directly into the 5.5mm plug of the cigarette lighter plug). (2) Select the appropriate sleeve, the square hole into the top of the electric wrench on the square head, you can release or tighten the bolt. According to the required direction of work, choose loose, tight switch. With the thumb to hold the corresponding direction switch, hear 1-2 times "despair, despair" after the crash can release the thumb, the whole process about 2-3 seconds. International buyers please note: a. The item "5 Ton Automotive Electric Car Jack Lift Van Garage 140mm-430mm 12V DC Heavy Duty" is in sale since Thursday, July 20, 2017.
This item is in the category "Automotive\Automotive Tools & Supplies\Shop Equipment & Supplies\Jacks & Jack Stands". The seller is "eddiestore2008" and is located in HK. This item can be shipped worldwide.